IR Gel before Convection Cure vs Full Infrared Cure for Infrared Powder-coating Cure
The expensive mistake is to change hardware before the job has a measurable definition. Start with the workpiece, the acceptance test and the operating envelope. That keeps the investigation narrow enough to learn from.
Compare the Same Job
A useful comparison holds the material, geometry, target and acceptance test constant. Otherwise the table compares two different processes.
| Decision factor | IR gel before convection cure | full infrared cure |
|---|---|---|
| Response | Confirm by measured ramp and control behaviour | Confirm by measured ramp and control behaviour |
| Product interaction | Test on the actual surface and thickness | Test on the actual surface and thickness |
| Integration | Check space, cooling, controls and interfaces | Check space, cooling, controls and interfaces |
| Release evidence | Same acceptance method for both | Same acceptance method for both |
The Deciding Test
Use representative material, a defined start condition and the real acceptance method. Establish a baseline, change one controlled variable, measure the result at more than one location and retain rejected as well as accepted samples. Oven-air or emitter temperature is not a substitute for time at metal temperature.
Where the Product Record Fits
The current Goldisgood record describes a half-white short-wave quartz infrared lamp family documented for industrial heating. That makes it a candidate to review only after the required part metal temperature, dwell and cured-film tests and mechanical/electrical interfaces are written down. Compare the documented record at Goldisgood industrial short-wave lamp record, then qualify the installed result on representative work. The catalogue is evidence of an available product family; it is not proof of suitability for this task.
Related Articles
- How to Diagnose Uneven The Coating Supplier’s Specified Time At Metal Temperature in Infrared Powder-coating Cure
- What to Measure before Changing Infrared Powder-cure Oven