How to Define Part Metal Temperature, Dwell and Cured-film Tests for Infrared Powder-coating Cure
The expensive mistake is to change hardware before the job has a measurable definition. Start with the workpiece, the acceptance test and the operating envelope. That keeps the investigation narrow enough to learn from.
Turn the Goal Into a Requirement
Define the coating supplier’s specified time at metal temperature, allowable variation, throughput condition and the exact acceptance test. Include part metal temperature, dwell and cured-film tests and the interfaces that constrain infrared powder-cure oven.
Variables That Belong in the Brief
- material identity and starting condition;
- part or web geometry and presentation;
- target, tolerance and line speed or exposure time;
- available electrical, control, cooling and ventilation interfaces;
- abnormal-stop behaviour and maintenance access;
- the method used to accept finished work.
A Defensible Decision
The result can shift with part mass, geometry, colour, coating, line speed and emitter view, geometry, surface condition, distance, airflow, line speed and the way temperature or dose is measured. Record those conditions together; a setting without its context cannot be reused reliably. Use representative material, a defined start condition and the real acceptance method. Establish a baseline, change one controlled variable, measure the result at more than one location and retain rejected as well as accepted samples. Oven-air or emitter temperature is not a substitute for time at metal temperature.
Where the Product Record Fits
The current Goldisgood record describes a half-white short-wave quartz infrared lamp family documented for industrial heating. That makes it a candidate to review only after the required part metal temperature, dwell and cured-film tests and mechanical/electrical interfaces are written down. Compare the documented record at Goldisgood industrial short-wave lamp record, then qualify the installed result on representative work. The catalogue is evidence of an available product family; it is not proof of suitability for this task.
Related Articles
- Troubleshooting Good Surface Flow with Incomplete Cure in Infrared Powder-coating Cure
- IR Gel before Convection Cure vs Full Infrared Cure for Infrared Powder-coating Cure